Monday 29 September 2014

More Loco Shed Work (1/35)

After the large front doors were fitted, I thought the rear door in the loco shed didn't quite match. I made a new from plastic card. The door is a tight push fit in the door opening. In that way I can remove the door if I need to take photos from that angle. I think some good shots could be made through the door and into the shed.
A rear view of the loco shed. The light indicates that the sun is setting over Nystrup  - and earlier and earlier now fall is approaching in Denmark. The door is new, as is the water tap to the right, I have been planting more grass and some Noch plants to the far left. The bike is from Scale Link.


The sides of the roof received a new layer of light green paint and a little weathering to match the new doors. The underside of the roof was painted black. While I worked on the shed, I drilled a hole for wires and LEDs for the welding light unit through the workbench (a resin part from a work shop set from Verlinden).

I added a bit of grass and plants around the shed. Being several years old now, some of the old grass was in for replacement (some tends to loosen and get lost during vacuum cleaning and general use of the module) and here and there a little more 'green' was needed. I used a few laser cut plants from Noch. Some of them are fine (the yellow and red/blue flowers) while others are not that good. I have placed them accordingly around the modules.
Laser cut paper flowers from Noch. A fast way to get some planting done, but not exactly cheap. At the current rate the amount on the price tag in Danish kroner corresponds to 10 €.

No comments:

Post a Comment